Crystal Audio 3D-HIFI360 - Mini Hi-fi System Quick Guide

TECHNICAL SPECIFICATIONS

CONNECTIVITY FEATURES

• Bluetooth® v5.0
• USB2.0 port
  up to 32Gb, FAT16/32 file system
  NTFS, ext. HDD, USB hubs/extension cables
• AUX In
• Headphones

OTHER FEATURES

• CD/CD-R/CD-RW/MP3/WMA
• FM Radio
• LED Display

IN THE BOX

• 3D-HIFI360 mini Hi-Fi system
• User Manual
• Remote Control
• AUX cable (3.5mm-RCA type)
• FM Antenna cable

1. In FM mode: Press GOTO
   
   
2. On LED display:
   
3. Num. Keypad: Enter FM frequency
   
   
4. Goto Frequency: Press PLAY
   
   
5. Once tuned: Press MEMORY
   
   
6. Set Position: Press CH-/+
   

Tune it (choose radio stations)

Program it (create a playlist, up to 9 songs)

1. In CD mode: Load a disc and press STOP. Press PROG and enter the first track number. Press PROG again to confirm. Enter the second number and follow the same procedure to set your playlist.
2. Play the list: When the list is completed press PLAY to confirm and listen to the music.

Loop it (play a section of a song)

Press A-B:
1x= set START point 2x= set END point The specific part of the song will be played repeatedly.

Control it

EQ Rock/Jazz/Pop/Flat
VOL -/+ Adjust Volume level
Mute Mute the sound
Pause Pause the music
A-B Loop a section of a song
Source Switch between all modes
CD/USB Select CD or USB mode
Search Auto tunning (FM Radio)
Random Play tracks in random order
Intro Play the 10 first seconds of each track on the disk. Press again to cancel the function
Memory Preset a radio station
Eject Open compact disc tray
Numeric Keypad Select track number
GoTo Enter FM Frequency
CH -/+ Select Next/Previous Radio station
Repeat Press 1 time: Repeat only one track
Press 2nd time: Repeat all tracks
Press 3rd time: Stop Repeat function
Treble -/+ Treble adjustment
Bass -/+ Bass adjustment FF -/+ Manual tunning (Radio stations)
Prog Create a playlist (up to 9 tracks)
Reset Back to factory deafult options
Pair Search for Bluetooth devices
BT Select Bluetooth mode

Care & Maintenance

Compact discs:

1. Treat disc carefully holding it by its edges.
2. Clean with a soft, dry cloth. Wipe from the center to the outer edge of the disc. Do not wipe in circular direction.
3. Do not stick or write anything on either side of the disc.

Unit:

1. To prevent shock hazard disconnect from the AC power source when cleaning the device.
2. Clean with a dry cloth. A dump cloth may be used on the front panel.

General instructions

Please read these safety instructions before using your device and store them for possible future reference.

1. If the cord is damaged, have it repaired by the manufacturer, its service or a similarly qualified person in order to avoid any hazard.
2. The power supply must be replaced by a new one in case of malfunction, because this power supply is not repairable.
3. The socket outlet shall be installed near the equipment and shall be easily accessible
4. The product is not intended for use by persons (including children) with reduced physi cal, sensory or mental capacity. Persons who have not read the manual, unless they have received explanations by a person responsible for their safety and supervision, should
5. Children should be monitored to ensure that they do not play with the product.
6. The cord should always be readily accessible.
7. The device should not be exposed to dripping or splashing of water or liquids and no objects filled with liquids, e.g.flower vases, should be placed on the product.
8. The normal ventilation of the product shall not be impended for intended use.
9. It is recommended to leave a minimum distance of 10 cm around the unit to ensure sufficient ventilation.
10. Open flame sources, such as candles, should not be placed on top of the device.
11. The device is intended for use only in a temperate climate.
12. 
    Danger of explosion if battery is incorrectly replaced or not replaced by the same type or equivalent.
13. The battery should not be exposed to excessive heat such as sunshine, fire or similar.
14. Different types of batteries, new and used batteries should not be mixed.
15. The battery must be installed according to the polarity.
16. If the battery is worn, it must be removed from the product.
17. The battery must be disposed of safely. Always use the collection bins provided for recycled items in order to protect the environment.

DECLARATION OF CONFORMITY
Radio equipment and telecommunications terminal equipment, Directive 2014/53/EU Crystal Audio hereby declares that the product, 3D-HiFi360, is in conformity with provisions of the Directive 2014/53/ΕU. The complete text of the Declaration of conformity can be found on the following webpage: www.CrystalAudio.gr

1. The lightning flash with the arrowhead symbol within an equilateral triangle alerts the user to the presence of un-insulated dangerous voltage within the product's enclosure that could cause electric shock.
2. The exclamation mark within an equilateral triangle alerts the user to the presence of important operating and maintenance instructions as well as warnings in the user's manual or on the product.

CLASS 1 LASER PRODUCT LABEL
This label is attached to the place as illustrated to inform that this device contains a laser component.