Advertisement
Installation Manual BM-8-906
Mounting Kit
Detailed Specifications BM-8-906
Capacity with load cell
Maximum vertical force (down) with dummy loadcell
Maximum vertical force (up)
Maximum horizontal force (with stay rod installed)
Maximum horizontal movement (without stay rod)
Assembly and Installation
Assembly:
-
Make sure the upper and base plate are correctly aligned (vertically).
-
Verify if the transport plate is mounted and already fastened tightly.
-
Loosen the hexagon bolts which assembled the loadcell dummy to the base plate.
-
Remove the dummy (load cell).
-
Assemble the separate pressure piece in the loadcell.
-
Apply some high pressure grease to the surface of the pressure installed in the loadcell.
-
Install the loadcell in the mount. To do this, insert the loadcell under an angle and make sure the rocker
supports fit into each other.
-
Make sure the spacer plate is located under the fastening end of the loadcell and put the bolts through
the loadcell, spacer plate and fasten them into the base plate.
-
Note: If you want to assemble a stay rod, please install it to the side holes on the mount.
Installation:
-
Please lift the container/silo with 1 to 2mm so that the mount(s) can be placed underneath.
-
Locate the mount(s) into the application and secure using the four lower and four upper fixing holes.
-
Remove the transport plate from the mount by removing the 4 socket head screws. See drawing.
-
Lower the container/silo again, so that the weight now rests on the installed loadcell(s) in the mount(s)
-
Install the earthing cable to one of the bottom plate holes of the transport plate and one of the holes of
the transport plate in the top plate, so that the top and bottom plate of the mount are connected.
-
Now adjust the bolt and nut from the lift-off protection on the head side of the mount. Make sure the
adjustable bolt doesn't touch the big bolt in the middle and fasten the nut to the steel element.
-
Only for assembly with stay rod: Secure the stay rod tightly, but make sure it does not apply any force on
the assembly!
-
This is done by adjusting the middle part by rotating it. Now fasten the nuts on the sides of the middle
part to make sure the set adjustment can't be changed.
Remove the transport plate
once the actual loadcell has
been properly installed.
Specifications and dimensions are subject to change without notice and do not constitute any liability whatsoever.
Nr. 2022.11 Installation Manual BM-8-906 Rev2
Page 2/5
0.15t – 2t
15 kN
15 kN
20 kN
+1.5 / -1.5 mm
Isometric View
2.5 – 5t
30 kN
30 kN
40 kN
Zemic Europe B.V.
T: +31 76 50 39480
info@zemic.nl
www.zemiceurope.com
Advertisement
