2.3.3 Setting the address switches earth. If you connect more than one IO 241 module in the system, you The module has been designed to ensure a good electrical must set the SW2 address switch correctly. SW2 has four bits contact to the DIN rail.
3. Product introduction 3.1 Product description The IO 241 module is an optional module for gaining extra input and output signals. It can be connected to the Grundfos IO 242 pump module and Grundfos control unit CU 241. Future modules and controllers may be supported.
Production site Markings and approvals 3.5 GENIbus GENIbus, the Grundfos Electronics Network Intercommunications bus, is a fieldbus developed by Grundfos to meet the need for data Pos. Description transfer in all typical Grundfos motor or pump applications. Grundfos devices with GENIbus can be wired together in networks Address switches for IO module.
Page 9
5. Lift the module off the rail (2). Removing IO 241 6. Fit the new module. 7. Connect all wires.
-7 to +12 VDC. 1. Use the public or private waste collection service. Nominal current condition: 4 mADC. 2. If this is not possible, contact the nearest Grundfos company or Short-circuit current condition: 328 mA. service workshop. Terminal impedance: 120 Ω.
Page 11
Tel.: +387 33 592 480 Centre Turkey Fax: +387 33 590 465 29-33 Wing Hong Street & 68 King Lam GRUNDFOS Pumper A/S GRUNDFOS POMPA San. ve Tic. Ltd. Sti. www.ba.grundfos.com Street, Cheung Sha Wan Strømsveien 344 Gebze Organize Sanayi Bölgesi E-mail: grundfos@bih.net.ba...
Need help?
Do you have a question about the IO 241 and is the answer not in the manual?
Questions and answers