JVC RV-DP200BK Service Manual page 14

RV-DP200BK
Removing the CD door switch board
Prior to performing the following procedure, remove
the main switch board and the micon board.
1. Remove the CD door switch board by pushing the
two tabs e inward.
Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the main switch board and the micon board.
1. Remove the four screws T attaching the CD
mechanism holder on the underside of the CD case.
2. Remove the CD mechanism holder and the CD
cushion from the CD mechanism assembly
respectively.
Removing the headphone / aux board
Prior to performing the following procedure, remove
the main switch board and the micon board.
1. Remove the two screws U attaching the headphone
/ aux board.
Removing the key switch board
Prior to performing the following procedure, remove
the main switch board and the micon board.
1. Extrude the operation panel assembly from the
underside of the CD unit toward the front while
pushing the four hooks f outward.
Pull out the two volume knobs from the operation
panel assembly.
Remove the ten screws V attaching the key switch
board on the reverse side of the operation panel.
1-14
(See Fig.24 and 25)
CD door switch board
Tabs e
Fig.24
(See Fig.25)
(See Fig.25)
(See Fig.26 to 28)
Headphone / Aux board
U
T
CD mechanism
assembly
The short-circuit
T
land
Hooks f
Operation panel assembly
Volume knob
V
Key switch board
V
U
CD door
switch board
Operation panel assembly
Fig.25
Hooks f
Fig.26
Volume knob
Fig.27
V
V
Fig.28