Table of Contents
Advertisement
Ref.
J4
SW1
U1
Back view
Ref.
J15
DF40C-80DP-0.4V(51) High Density connector
3.2 DIP Switch
The DIP switch allows for boot mode configuration:
BOOT SEL: When set to ON, keeps the Portenta in Boot mode.
BOOT: When set to ON enables the embedded bootloader. Firmware can be uploaded via the USB port on the
breakout board (DFU). USB-A to USB-A (non-crossover) cable required. The Portenta H7 has to be powered
through the USB-C® connector or VIN.
7 / 18
Description
Cam connector
Boot mode selection
USBA power switch IC
Bottom view - connectors
Description
Arduino® Portenta Breakout Board
Arduino® Portenta Breakout Board
Ref.
J16
DF40C-80DP-0.4V(51) High Density connector
Ref.
Description
J8
Power terminal block
PB1
Power ON button
Description
Modified: 14/02/2023
Advertisement
Table of Contents
