Advertisement
INSTRUCTIONS–PARTS LIST
Parts
AIR-ASSISTED AIRLESS ELECTROSTATIC
Gun Washer Kit
Part No. 236659
For use with Graco Gun Washer to clean the PRO
AA4500 Electrostatic Spray Gun. The kit enables you
to clean exterior gun surfaces and internal fluid pas-
sages without getting solvent into the air passages or
turbine.
Observe all warnings. Read and understand all
instruction manuals before operating equipment.
To reduce the risk of serious injury, including
splashing fluid or solvent in the eyes or on the
skin, shut off the air to the pump, relieve all sys-
tem pressure, and drain the solvent from the
gun washer tank before installing the kit.
Install Gun Support, Trigger Lock, and
Fluid Inlet Adapter
1. Relieve the gun washer system pressure.
2. Remove a gun support (A) or spray nozzle (B)
from one of the four cleaning stations. See Fig. 1.
NOTE: To ease removal of the spray nozzle, re-
move the metal platform from the gun washer
tank.
3. Remove the spray nozzle that is next to the station
where you will install the PRO AA4500 gun sup-
port (4) and install the plug (6). See Fig. 2.
4. With the metal platform (C) in place, screw the
PRO AA4500 gun support (4), supplied with the
kit, into the 1/8" npt hole. Orient the support so it
faces the center of the gun washer.
This manual contains important
warnings and information.
READ AND RETAIN FOR REFERENCE
See manual 308393 for complete gun
washer warnings and instructions.
WARNING
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
ECOPYRIGHT 1999, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
5. If the gun support (4) replaced a spray nozzle (B–
See Fig. 1), install the trigger lock (7) and fluid inlet
adapter (5) to use with the fourth gun station. See
Fig. 2. Place the wire loops on the snap ring (8)
and snap it around an open spray nozzle.
A
B
Fig. 1
8
7
6
4
Fig. 2
308411
Rev. B
A
03669
5
C
03670
Advertisement
Table of Contents
Related Manuals for Graco 236659
Summary of Contents for Graco 236659
- Page 1 See Fig. 1), install the trigger lock (7) and fluid inlet adapter (5) to use with the fourth gun station. See For use with Graco Gun Washer to clean the PRO Fig. 2. Place the wire loops on the snap ring (8) AA4500 Electrostatic Spray Gun.
- Page 2 Install Air Cap Blank and Tip Housing 3. Using the parts from the kit, press the two washers (3) into the tip housing (2) and press the tip hous- WARNING ing into the air cap blank (1). See Fig. 4. 4.
- Page 3 WARNING To reduce the risk of electrostatic shock, fire, or explosion; which could result in serious injury and property damage, be sure to follow these precautions. D Make sure the ES ON-OFF valve lever (elec- trostatics) is OFF before cleaning the gun. D Never allow solvent to enter the air passage of any electrostatic gun.
- Page 4 Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
Need help?
Do you have a question about the 236659 and is the answer not in the manual?
Questions and answers