Operation - ABSINA 52-230-1002 Operating Manual

• Only connect the charging cable to vehicle inlets and
household sockets that are protected from water,
direct sunlight, moisture and other liquids.
• Some electric vehicles allow the vehicle to be started
with the charging cable plugged in. Always make
sure to disconnect the charging cable before driving
off.
• Do not use the charging cable with an extension
cable or an adapter. Modifications or alterations are
dangerous to life and will immediately void the
warranty.
• If the plug connection smokes or melts, never touch
the charging cable. If possible, stop the charging
process. Disconnect the relevant mains socket from
the power supply (fuse, FI, switch).
• Make sure that the charging cable is not accessible
to children. Only persons with a valid driving licence
for motor vehicles may operate the charging cable.
• Only use the cable in protected outdoor areas.
Start charging
1
1
End charging
1
1
WALLBOX
WALLBOX
SchuKo
SchuKo
2
2
2
2
Typ2 auf Typ2
Typ2 auf Typ2
Deutsch . English . Français . Español . Italiano

OPERATION

1. Read the instructions for the charging cable and
the vehicle completely and carefully.
2. Switch off the vehicle engine and put the gear
lever in park.
3. Connect the mains plug of the charging cable to a
suitable socket (230V 16A).
4. The green LED lights up to indicate that the vehicle
is ready for charging.
5. Remove the protective cap from the charging plug
and connect the plug to the vehicle' s charging
socket.
6. The charging process starts automatically as soon
as the blue LED starts flashing.
7. Charging is complete when the green LED and the
blue LED light up continuously.
8. When the charging process is finished, pull the
charging plug out of the charging socket of the
vehicle and then pull the mains plug out of the
mains socket (vehicle must be unlocked).
9. Put the protective cap on the charging plug and
roll up the cable without kinks.
3
3
3
3