B Setting Up For Use - BLUGARDA BluFeeder Manual

3.B SETTING UP FOR USE

1. Setting the current time
Briefly press the SET button again to move to minute and set it to the current
minute using the up or down button.
2. Setting the feeding distance
Briefly press SET again to set the feed distance. The letter L starts to flash. Use
the UP and DOWN buttons to set the feed distance as desired.
S - Short feeding range up to approx. 1 metre. Motor speed runs at 60%.
EN
M - Medium feeding range up to approx. 2 metres. The motor speed runs at 80%.
L – Long feeding range up to approx. 3 metres. Motor speed runs at 100%.
3. SETTING THE FEEDING CYCLE
3.1 Setting the feeding frequency
3.2 Setting the feeding time
8
Switch the on/off switch on the side of the de-
vice to on(I).
The display will become visible, as shown in the
picture opposite.
Briefly press the SET button to set the current
time, starting with hour. Set it to the correct hour
using the UP or DOWN button.
Set the desired number of feeding frequencies
as shown in the figure opposite. The SET TIM-
ER indicates that you are setting the time of a
feeding cycle. The number next to it indicates
the feeding cycle selected. There are 6 cycles
per day to set. Hold down the SET button brief-
ly and set the cycle time by pressing the UP
and DOWN buttons.
Set the desired feeding time during the cycle
as shown in the figure opposite.
Use the UP and DOWN button to set the feed-
ing time. A time can be set between 0 and 20
seconds. A time of 0 means there will be no
feeding during this cycle.
BluFeeder manual