Front Panel Facilities - Pioneer TX-9500II Service Manual

3. FRONT PANEL FACILITIES
POWER SWITCH
Set to ON position to turn on power. Pilot lamp will light.
MULTIPATH ON: Multipath sound becomes audible
from speakers. When installing FM
antenna, select antenna location and
direction so as to minimize this sound.
Normally set switch to this position.
REC LEVEL CHECK ON: Use this position for setting
recording levels of tape deck. A 44OHz
signal (level corresponding to 50% FM
modulation) is produced at approxi-
mately 1.7 second intervals.
S I G N A L M E T E R
E m p l o y w h e n t u n i n g A M
t u n i n g p o i n t o c c u r s w h e n
toward the right is obtained.
a n d F M s t a t i o n s . O p t i m u m
maximum meter deflection
T U N I N G
Use whe
deflectio
tune care
( o p t i m u m
M U T I N G
Controls
noise wh
tuning op
2 :
O F F :
P I L O T L A M P
I F B A N D S W I T C H
F M l F ( i n t e r m e d i a t e
for wide or narrow.
frequency) passband can be set to
W I D E :
Normally set switch to this position.
NARROW:
lf adjacent station interference is a pro-
blem at the WIDE setting, set switch to
t h i s p o s i t i o n .
M U L T T P A T H / R E C L E V E L C H E C K S W T T C H
M E M O R Y M A R K E R S
Single lever operates both MULTIPATH and REC LEVEL
CHECK switches. With the FUNCTION switch at FM, set
as required for the application. Be sure to return it to the
OFF position when it is not being used.
t F B A N D I N D I C A T O R
Convenient for designating most often tuned in stations.
Slide markers with fingertip to desired positions.
O U T P U T L E V E L C O N T R O L
Adjusts level at OUTPUT (VARIABLE) jacks. Clockwise
rotation increases output level.
O F F :