Table of Contents
Advertisement
2.2 Alarm Activation
Press and hold the button corresponding to the desired alert (refer to figure 2 and table 1)
Note that, to avoid accidental activation, the button must be held down for at least one
second for an alert activation request to be transmitted to the network
2.3 Alarm Deactivation
To disable an alert you must press the DEACTIVATE button. Pressing the same button
again while the alert is activated will have no effect.
The Remotes and Fixed Control Panels continue to transmit for approximately 8 seconds
after the button is released to ensure good signal reception.
To minimise noise pollution, all alerts automatically de-activate after 10 minutes of
continuous activation.
When a Remote or Fixed Control Panel transmits a message, all other activation controls will
be ignored by the network for approximately 10 seconds after the transmission.
WiLAS Installation & User Guide
9
Advertisement
Table of Contents
