13. MIG: Changing Your Torch Liner (Aluminium)
1. Remove MIG torch front end parts.
3. Carefully pull out and completely remove the existing
liner. Ensure MIG torch is completely unravelled until
setup is complete.
5. Feed liner and neck spring through the torch, then fit
liner collet, liner O-ring and liner retaining nut.
2. Remove the liner retaining nut.
4. Fit the neck spring to the front end of the aluminium
liner.
6. Push the liner firmly into the torch lead and tighten the
liner retaining nut.
31
VIPER MIG 165
OPERATING MANUAL