Table of Contents
Advertisement
4.5
Installation
After you have assembled the Enmix by following the steps in section 4.4, it can now be installed.
Installing the Enmix is fairly simple, but we advise that these activities are performed by two
people, in view of the combination of the dimensions and weight.
Before placing the Enmix on the liquid tank, check that the centre-to-centre distance of the frame
corresponds with the dimensions of the liquid tank. After you have checked this, the Enmix can be
lifted or hoisted onto the liquid tank. Make sure that both sides of the frame are resting on the
side of the tank, and check that the mixer blade (11) is suspended approximately 80mm above
the bottom of the tank. You can now drill the holes in the liquid tank, using an 8mm drill bit,
through the extensions (1) of the frame. After drilling the holes, we recommend that you
immediately attach the extension (1) to the liquid tank with the supplied m8 bolts, nuts and
washers. If you wish, you can cut them to size in advance.
When all four of the extensions (1) of the Enmix frame have been attached to the liquid tank, you
must check that the mixer blade (11) can rotate freely in the tank. You can check this by
manually rotating the mixer shaft (8).
4.6
Electrical connection
The Enmix must be electrically connected in conformity with NEN-1010. Table 5 shows the
specifications of the various motors with reduction gearbox.
Data of motors with reduction gearbox
Frequency
Voltage
50 Hz
230 V
50 Hz
400 V
60 Hz
440 – 480 V
60 Hz
480 V
60 Hz
575 – 600 V
Other frequencies and voltages are available on request.
The 575V variant of the motor with reduction gearbox is optionally available with a 1.5m cable. If
this is used, it must be connected as described below.
PLEASE NOTE: Make sure that there is no voltage present at the terminal connectors when
connecting the cable!
•
L1
=
•
L2
=
•
L3
=
•
L4/L5
=
The certifications of the motors with reduction gearbox can be provided on request.
4.7
Start-up
After the Enmix has been completely assembled, installed and electrically connected, you can
start it up. Chapter 5 describes how the start-up of the Enmix must be performed.
PLEASE NOTE: To ensure a longer service life, we recommend that the motor with reduction
gearbox should not be started/stopped more than 20x per hour.
Van der Ende Groep · Aartsdijkweg 23, 2676 LE Maasdijk, the Netherlands
+31 174 515 050 · info@vanderendegroep.nl · www.vanderendegroep.com
Current
Speed
2.0 A
1370
1.2 A
1410
1.2 A
1680
0.9 A
1715
0.7 A
1680
Table 5: Data of motors with reduction gearbox
Phase 1
Phase 2
Phase 3
PTC
Page 15 of 26
Phases
Cos φ
Weight
1 phase
0.96
6.2 kg
3 phase
0.69
5.4 kg
3 phase
0.69
5.4 kg
3 phase
0.67
9.5 kg
3 phase
0.72
8.0 kg
Quality mark
CE
CE
CE
cURus
cURus
IMPROVING YOUR BUSINESS
Advertisement
Table of Contents
