Table of Contents
Advertisement
Troubleshooting
Problem
Ethernet Link LED is
OFF or intermittent
Power Line LED is
not ON
14
Cause
Port connection
is not
functioning
Normal/Uplink
push button is
in the wrong
position
Incorrect Cable
used to connect
to the router
System not
Initializing
Solution
•
Make sure the power cord is properly
connected at both ends.
•
Make sure that the cable plug is
properly inserted and locked into the
port at both the hub and the device.
•
Make sure all cabling is Category 5 and
meets the requirements for 10 Mbps
operation.
•
Check Link LEDs on attached Ethernet
devices or the network adapter cards.
•
If you are having trouble connecting
the XE602 to an Ethernet Hub or
switch; connect it to the port that
supports an uplink and press the uplink
button.
•
Check the Normal/Uplink push button
on the front panel of the hub, switch or
router.
•
Exchange the supplied Ethernet patch
cable with the Ethernet crossover cable.
•
Recheck your connections and the
Power LED is ON.
Advertisement
Table of Contents
