Before Installation - Kogan NBBR3HOSMSL User Manual

BEFORE INSTALLATION

Expose the solar panel to sunlight for eight hours to ensure a sufficient charge.
Press the mode button to switch on the light prior to installation.
INSTALLATION
Ensure the light is installed at a height between three and five metres above the ground.
Installing onto a masonry wall
1. Detach the bracket from
the light.
4. Insert the wall plugs into
the drilled holes.
2. Place the bracket on the
wall where you would like
to install the light. Using
a pen (not supplied),
mark the positions of the
three holes of the
bracket.
5. Align the bracket with the
holes. Using a Phillips
screwdriver (not
supplied), secure the
bracket with the screws.
3. Using a drill and 5.8mm
drill bit (not supplied), drill
holes 28mm deep
through the three
marked positions.
6. Attach the light onto the
bracket.