General Care - Crewsaver CREWFIT 180N PRO Service Manual

Crewsaver - Servicing Manual : Crewfit 180 Pro Lifejacket
2.3

General Care

2.3.1 The Lifejacket should be stowed in accordance with the manufacturer's instructions.
2.3.1.1 Lifejackets should be stowed in a dry compartment. Avoid high humidity, such as a car boot.
2.3.1.2 Automatic Lifejackets should have stowage facilities which are provided with a method to
encourage moisture removal.
2.3.1.3 Lifejackets should be stowed vertically, for example hung on hooks, in order that any trapped water
or condensation can drain away naturally.
2.3.1.4 Lifejackets should be rinsed in fresh water and dried thoroughly after use.
Prior to sponging or washing remove automatic capsules from the firing mechanism. Allow to dry thoroughly
2.3.2 Contaminants such as oil or diesel fuel may be sponged off immediately with clean water and allowed
to dry naturally.
2.3.3 Mud can be removed with a stiff (not wire) brush when dry.
2.3.4 The outer cover may be hand washed in good quality mild detergent in cool water (40 C). Rinse well, drip dry
naturally in air.
2.3.5 Sponge the inflation chamber with pure soap solution only. Rinse in clean water immediately, inflate and
allow to dry naturally in air.
2.3.6 In cases of severe contamination the unit shall be deemed beyond economic repair and the customer
advised to purchase a replacement lifejacket.
Date: May 2016
Issue No: 2
Do not use proprietary cleaning fluids, thinners, spirits or similar substances.
WARNING
afterwards.
WARNING
Section 2
o
Page
9
f 28
O