3.1 Trigger Mode
If the Trigger Mode is enabled, you could activate the scanner by providing an external hardware trigger, or
using a serial trigger command. When in manual trigger mode, the scanner scans until a barcode is read, or until the
hardware trigger is released. When in serial mode, the scanner scans until a barcode has been read or until the deactivate
command is sent.
Serial Trigger Command:
Command Trigger:
Command Untrigger:
PA2K User Manual I Page 19 of 103
3 General Configuration
Manual Trigger Mode – Normal
[0x02][0xF4][0x03]
[0x02][0xF5][0x03]