If The Indicator Lights - Panasonic ET-SFR330C Operating Instructions Manual

Smoke cut filter

Smoke cut filter replacement cycle (continued)

Filter Remaining Time

-　 - 　 -

12 to 0 (hours)

Note

z When the remaining time reaches 0, the projector's light output will be limited to 50% or less to protect the

projector. The output limit will be released after the smoke cut filter is replaced with a new one.

z The [FILTER REMAINING TIME] item will only appear in the [STATUS] screen when the projector's [FILTER

TYPE] setting is set to [SPECIAL].

If the indicator lights...

Check the status of the indicator, and perform the following solutions.

■ Status : Lit red

Situation : The filter is clogged

or the environment or inside of the projector is very hot.

Check

Is the smoke cut filter dirty?

Is the air intake/outlet blocked?

Is the projector being used more than

1 400 m (4 593') above sea level?

Note

z We recommend replacing the smoke cut filter within 10 hours of the filter indicator < 过滤网 > lighting.

z Prolonged operation without replacement of the smoke cut filter may reduce the lifespan of parts and result in

malfunctions.

z If the filter indicator < 过滤网 > still lights or flashes, even after doing the above, contact your dealer for repairs.

日本福冈县福冈市博多区美野岛四丁目1番62号

https://panasonic.cn/

Filter clogging has not occurred.

Filter clogging has occurred.

Filter indicator < 过滤网 >

2022

Status

Replace the smoke cut filter. (

Remove the object blocking the air intake/outlet.

Use the projector in a location lower than 1 400 m

(4 593') above sea level.

Solution



Page 3)

HS0916AM1042 -PS

Printed in Japan

Table of Contents