Valcom VIP-903 Quick Start Manual

INSTALLATION
1. Insert left and right slide bracket into the
groove of the VIP-903, Rack Mount VIP three
position. Slide brackets to the front of the unit
so that the oblong holes of the brackets line up
to the notch on the front panel.
2. Insert the VIP-903 into a 19 inch rack. Line
up the mounting holes of the unit to the threaded
holes in a 19 inch rack.
3. Insert a 10-32 X 3/4 inch machine screw into
the slots for the slide brackets first and tighten.
The VIP-903 unit can now slide out of the rack
so that the VIP units can be easily mounted.
4. Connect power supply in the back of the unit
to the wall outlet.
5. Mount a VIP unit in the VIP-903 by first sliding
the unit into the opening of the front panel.
PCB Power Strip
Left Slide Bracket
6-32 X 1/4" Machine
Screw For Bracket
VIP Unit Bracket
VIP Unit
VIP-903
Front Panel Cover Plate
VIP-903
RACK MOUNT KIT
19" Rack
6-32 Nut
1
Slide the VIP unit bracket up against the back of
the unit and tighten the 6-32 X 1/4 inch machine
screw for the bracket.
6. Insert one of the cables that is attached to the
PCB power strip to the mating connector on the
back of the VIP unit.
7. If more than one unit is mounted in the
VIP-903, then the front panel cover plate has to
be removed. These cover plates are removed
by removing the 6-32 nut on the back of the
front panel and then lifting the cover plate out.
8. Repeat steps 5 and 6 for mounting the other
VIP units.
8. After the VIP units are mounted in the
VIP-903, then slide the unit back into the rack.
Attach the VIP-903 to the 19 inch rack with four
10-32 X 3/4 inch machine screws.
Right Slide Bracket
Power Supply
10-32 x 3/4"
Machine Screws
(6 Places)
ISSUE 1
947228