Zeegma Zonder Robo Vision User Manual page 9

Dustbin (see fig. 4):
1.
HEPA filter
2.
Preliminary filter
3.
HEPA filter sensor
Docking station (see fig. 5):
7.
Power LED
8.
Power port
9.
Charging port
Remote control (see fig. 6):
10.
Return to docking station
11.
Forward key
12.
Start/pause key
13.
Turn right
14.
Turn left
3. How to assemble (see fig. 7):
•
Fix the side cover for dust bin emptying: Firmly press the side cover and adapt to two
fasteners.
•
Close the side cover for dust bin emptying.
•
Install the dustbin in the relevant place of the vacuum cleaner.
•
Before you use the product, remove the protective strip.
4. How to use:
How to place and charge:
•
Place the docking station by the wall, on a flat surface. Leave some free space around
the station, that is 0,5m to the left and right, and 1,5m before the station (see fig. 8).
•
Supply power to the docking station and plug in (see fig. 8).
•
Fix side brushes, left and right (L/R) (see fig. 9).
•
Place the device on the floor. Turn on the main switch (see fig. 9).
Caution! Any interference with the operation of the device (lifting, moving, remote
control of the device, etc.) may disrupt the cleaning process and cause errors in the
positioning of the device in the room.
If the device needs to be stopped, press the pause button (2, fig. 2). Do not change the
position of the device.
4.
HEPA filter cover
5.
Correct tank assembly sensor
6.
Side cover for tank emptying
15.
Reverse key
16.
Edge cleaning
17.
Spot cleaning
18.
Suction power adjustment
EN