Advertisement
WARNING
Disconnect the plug by holding onto it instead of
pulling on the cord.
- Failure to do so may cause the wire in the cord to
break, and may cause burn, electric shock, or fi re due
to a short circuit.
Regularly clean the plug to prevent dust from
accumulating.
- Failure to do so may cause fi re due to insulation failure
caused by humidity.
Disconnect the plug and wipe with a dry cloth.
Always turn off the power switch and disconnect
the plug from the household outlet after use.
- Failure to do so may cause fi re or burn.
Use the household outlet alone: do not use with an
extension cord.
Fully insert the plug.
Always ensure the appliance is operated on an
electric power source matched to the rated voltage
indicated on the appliance.
- Failure to do so may cause fi re or electric shock.
When the hair dryer is used in a bathroom, unplug it
after use since the proximity of water presents a
hazard even when the hair dryer is switched off.
- Failure to do so may cause an accident or injury.
For additional protection, the installation of a
residual current device (RCD) having a rated
residual operating current not exceeding 30 mA is
advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
- Failure to do so may cause an accident or injury.
EH-NA67 AUS_EH9210NA677651.indb 5
EH-NA67 AUS_EH9210NA677651.indb 5
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent, or similarly
qualifi ed persons in order to avoid a hazard.
- Failure to do so may cause an accident or injury.
►In case of an abnormality or malfunction
Immediately stop using and remove the plug if there
is any abnormality or malfunction.
- Failure to do so may cause fi re, electric shock, or
injury.
<Abnormality or malfunction cases>
• Air is not emitted
• Unit stops sporadically
• Interior becomes red-hot and smoke is emitted
• The appliance is damaged or deformed, or strange
noise is emitted.
- Immediately request inspection or repair at an
authorized service center.
►Maintenance
If you see sparks around the air outlet while using
the hot air setting, stop use and remove the lint on
the air outlet and air inlet.
- Failure to do so may cause burn or fi re.
►This appliance
Do not block or insert hair pins or other foreign
objects into the air inlet, air outlet or nanoe™ outlet.
- Doing so may cause fi re, electric shock, or burn.
5
21/4/2565 BE 10:22
21/4/2565 BE 10:22
Advertisement
