Advertisement
Quick Links
Halsey Taylor Instruction Manual
To avoid the risk of electrical shock, personal injury, or death, disconnect power and water
supplies before installing this plumbing kit.
To avoid property damage, personal injury, and voiding your warranty:
* have an authorized person install your plumbing kit
* make sure you read, understand, and follow the attached instructions
* wear protection to protect yourself from sharp edges
* wear safety goggles to protect your eyes from water under pressure and other
projectiles
Refer to the parts list to make sure you received all plumbing kit parts. If any parts are
missing, contact your Halsey Taylor dealer.
You will need the following tools to install your plumbing kit:
- flat blade screwdriver
- adjustable wrench
- tubing cutter
- phillips screwdriver
- 5/16" nut driver or socket
Glass Filler Plumbing Kit
Model: 73-42485-51-550
HAC-4F
HAC-4FS
WARNING
CAUTION
PARTS LIST
PARTS LIST
ITEM NO.
PART NO.
1
100322740560
GASKET-BLACK (QTY OF 4)
2
50090C
INSULATION-ARMAFLEX
3
50279C
TAPE-ARMAFLEX INSULATING
4
60119C
TUBE-CU 1/4 X 5.00"
5
62296C
ASSY-BUBBLER TUBE (QTY OF 2)
6
70682C
FITTING-TEE 1/4
7
70683C
FITTING-UNION 1/4
REQUIRED TOOLS
HAC-8F
HAC-FS
DESCRIPTION
92874C (Rev. A)
Advertisement
Related Manuals for Halsey Taylor HAC-4F
Summary of Contents for Halsey Taylor HAC-4F
- Page 1 * wear safety goggles to protect your eyes from water under pressure and other projectiles PARTS LIST Refer to the parts list to make sure you received all plumbing kit parts. If any parts are missing, contact your Halsey Taylor dealer. PARTS LIST ITEM NO. PART NO.
- Page 2 REMOVE THE FRONT PANEL AND BASIN 1. Disconnect the electric power and shut off the cold water supply. Press the push bar to relieve any residual water pressure. 2. Remove the four front panel screws and remove the front panel. 3.
- Page 3 INSTALLING GLASS FILLER PLUMBING The plumbing in your water cooler should look like the illustration shown in Fig.1 at the bottom of this page. Use the following instructions to install the glass filler in your cooler. IMPORTANT NOTE: INLET SIDE OF REGULATOR HOLDER WAS CHANGED IN EARLY 1997. MAKE NOTE OF THIS LOCATION ON YOUR UNIT BEFORE CUTTING ANY TUBES! AFTER THE INLET IS LOCATED, READ OVER AND USE THE FOLLOWING DIAGRAMS AS A REFERENCE TO FAMILIARIZE YOURSELF WITH THE TUBES THAT ARE TO BE CUT AND WHERE THEY ARE TO...
- Page 4 FINISHING THE INSTALLATION 1. Verify that the plumbing is connected as shown in Fig.3 on page 3. 2. Wrap all exposed copper tubing with the foam tube supplied with the kit. CAUTION! To avoid water damage, never re-use old bubbler gaskets. 3.