Page 1
* wear safety goggles to protect your eyes from water under pressure and other projectiles PARTS LIST Refer to the parts list to make sure you received all plumbing kit parts. If any parts are missing, contact your Halsey Taylor dealer. PARTS LIST ITEM NO. PART NO.
Page 2
REMOVE THE FRONT PANEL AND BASIN 1. Disconnect the electric power and shut off the cold water supply. Press the push bar to relieve any residual water pressure. 2. Remove the four front panel screws and remove the front panel. 3.
Page 3
INSTALLING GLASS FILLER PLUMBING The plumbing in your water cooler should look like the illustration shown in Fig.1 at the bottom of this page. Use the following instructions to install the glass filler in your cooler. IMPORTANT NOTE: INLET SIDE OF REGULATOR HOLDER WAS CHANGED IN EARLY 1997. MAKE NOTE OF THIS LOCATION ON YOUR UNIT BEFORE CUTTING ANY TUBES! AFTER THE INLET IS LOCATED, READ OVER AND USE THE FOLLOWING DIAGRAMS AS A REFERENCE TO FAMILIARIZE YOURSELF WITH THE TUBES THAT ARE TO BE CUT AND WHERE THEY ARE TO...
Page 4
FINISHING THE INSTALLATION 1. Verify that the plumbing is connected as shown in Fig.3 on page 3. 2. Wrap all exposed copper tubing with the foam tube supplied with the kit. CAUTION! To avoid water damage, never re-use old bubbler gaskets. 3.