Page 1
USER MANUAL ENGLISH EDGE ED-1 Product code: D1485 Highlite International B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands...
Page 2
EDGE ED-1 Preface Thank you for purchasing this DAP product. The purpose of this user manual is to provide instructions for the correct and safe use of this product. Keep the user manual for future reference as it is an integral part of the product. The user manual shall be stored at an easily accessible location.
EDGE ED-1 Table of contents Introduction ................................3 Before Using the Product ..........................3 Intended Use ............................... 3 Product Lifespan ..............................3 Text Conventions ..............................3 Symbols and Signal Words ..........................4 Symbols on the Information Label ........................4 Safety ..................................5 Warnings and Safety Instructions ........................
After unpacking, check the contents of the box. If any parts are missing or damaged, contact your Highlite International dealer. Your shipment includes: ● DAP EDGE ED-1 ● AC power adapter (0,9 m) ● Schuko to IEC power cable (1,3 m) ●...
EDGE ED-1 Symbols and Signal Words Safety notes and warnings are indicated throughout the user manual by safety signs. Always follow the instructions provided in this user manual. Indicates an imminently hazardous situation which, if not avoided, will result in DANGER death or serious injury.
EDGE ED-1 Safety Important Read and follow the instructions in this user manual before installing, operating or servicing this product. The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual. Warnings and Safety Instructions...
EDGE ED-1 Attention This device shall be used only for the purposes it is designed for. This device is designed to be used as an antenna distributor. Any incorrect use may lead to hazardous situations and result in injuries and material damage.
Description of the Device The DAP EDGE ED-1 is a 4-way antenna distributor that can be used in setups with 4 or more receivers. The device can be used as the power supply for the receiver and for the antennas in the setup.
EDGE ED-1 Installation and Setup Ambient Conditions ● The device can be used only indoors. ● The maximum ambient temperature t = 50 °C must never be exceeded. ● The relative humidity must not exceed 50 % with an ambient temperature of 50 °C.
EDGE ED-1 Two Devices Attach the supplied short mounting brackets with the mounting screws to the devices. Use a Phillips screwdriver to tighten the mounting screws. Fig. 06 Attach the supplied mounting plate with the mounting screws to the bottom of both devices. Use a Phillips screwdriver to tighten the mounting screws.
EDGE ED-1 Setup Attention Connect all data cables before supplying power. Disconnect power supply before connecting or disconnecting data cables. It is possible to connect accessories to 1 or more antenna distributors, to provide better signal reception for the connected receivers. See 3.4. Accessories on page 8 for more information.
EDGE ED-1 Setup with Single Device In a setup with 1 antenna distributor, you can connect up to 4 receivers and 1 set of unidirectional/omnidirectional antennas. The antennas receive the signal from the transmitter(s) and send it to the antenna distributor. The antenna distributor sends the signal to each connected receiver.
EDGE ED-1 Setup with Two Devices In a setup with 2 antenna distributors, you can connect up to 8 receivers and 1 set of unidirectional/omnidirectional antennas. The antennas receive the signal from the transmitter(s) and send it to the antenna distributor. The antenna distributor sends the signal to the other connected antenna distributor.
EDGE ED-1 Connecting to Power Supply Attention Incorrect handling of the AC power adapter may result in hazardous situations This device is delivered with an AC power adapter. Incorrect handling of the AC power adapter may result in hazardous situations.
EDGE ED-1 Maintenance Preventive Maintenance Attention Before use, examine the device visually for any defects. Make sure that: ● All screws used for installing the device or parts of the device are tightly fastened and are not corroded. ● There are no deformations on housings, fixations and installation points.
Approval Hereby, Highlite International declares that the device EDGE ED-1, product code D1485, is in compliance with Directive 2014/53/EU (RED – Radio Equipment Directive). The full text of the EU declaration of conformity is available at the respective product page on the website of Highlite International (www.highlite.com).