Configuring Wan Setup Options - NETGEAR WGR101 Reference Manual

Reference Manual for the 54 Mbps Wireless Travel Router WGR101
If your Internet connection does not require a login, fill in the settings according to the
2.
instructions below.
Enter your Account Name (may also be called Host Name) and Domain Name.
a.
These parameters may be necessary to access your ISP's services such as mail or news
servers.
Internet IP Address:
b.
If your ISP has assigned you a permanent, fixed (static) IP address for your computer,
select "Use static IP address". Enter the IP address that your ISP assigned. Also enter the
netmask and the Gateway IP address. The Gateway is the ISP's router to which your router
will connect.
Domain Name Server (DNS) Address:
c.
If you know that your ISP does not automatically transmit DNS addresses to the router
during login, select "Use these DNS servers" and enter the IP address of your ISP's
Primary DNS Server. If a Secondary DNS Server address is available, enter it also.
Note: If you enter an address here, restart the computers on your network so that these
settings take effect.
MAC Address:
d.
This section determines the Ethernet MAC address that will be used by the router on the
Internet port. Some ISPs will register the Ethernet MAC address of the network interface
card in your computer when your account is first opened. They will then only accept
traffic from the MAC address of that computer. This feature allows your router to
masquerade as that computer by "cloning" its MAC address.
To change the MAC address, select "Use this MAC address" and enter it.
Click Apply to save your settings.
e.

Configuring WAN Setup Options

The WAN Setup options let you configure a DMZ server and enable the wireless travel router to
respond to a Ping on the WAN port. These options are discussed below.
6-4
February 2005 (202-10034-03)
Network Configuration