Page 1
Highly flexible telemetry systems can be developed with these simple devices. The COE-8 system also supports SNMP for independent monitoring and control. Up to 4 SNMP managers can be configured to support the COE-8.
Connect the network to the connector provided. A yellow LED indicates a successful connection to the network, a green LED data activity. Power Apply power only when the cover is secured onto the COE-8. Use RELAY OUTPUT only the wall mounted power supply provided. For applications N.O.
WEB Page Access The web pages provide status information on the inputs and outputs of the COE-8, as well as provide configuration for the unit. Open a browser to the default or current IP address of the unit. Enter the...
Page 4
2) DHCP WEB Page Login to the COE-8 and access the Setup pages by clicking on the Setup button from the home page. Click on the IP button to bring up the IP Settings page: Select Static Mode from the radio buttons and fill in the IP Address, Subnet Mask and Gateway as provided by your network administrator.
Page 5
If a port other than the default Port 80 is used for web browser access, that port must specifically be used in the URL when accessing the COE-8. For example, if the Web Port is changed to 9090 then the URL for the unit would be http://192.168.1.254:9090...
Page 6
Enter the IP addresses of up to 4 SNMP managers. Enable or Disable SNMP with the checkbox provided. Traps can be sent every time there is a change of state on any COE-8 channel. Check the box provided to enable this. If both the COE-8I and COE-8O are configured to send traps, two messages will be received by each SNMP manager for each event.
Page 7 TECHNICAL SUPPORT, RETURNS and WARRANTY Dataprobe Technical Support is available 8:30AM to 5:30PM ET to assist you in the installation and operation of this product. To obtain Technical Support call our Tech Support Hotline at 201-967- 8788, or Email us at tech@dataprobe.com. Please have the following information available when you call: •...