Related Manuals for Fideltronik Inigo LUPUS 600N
Summary of Contents for Fideltronik Inigo LUPUS 600N
- Page 1 USER MANUAL UPS LUPUS 600VA - 1500VA (Line Interactive UPS with AVR) (220/230/240VAC) ( www.fideltronikinigo.pl ) Version: 1.2 2022...
-
Page 2: Safety Instruction
SAFETY INSTRUCTION Thank you for purchasing this power protection product. Please read manual carefully and remember about all warnings and operating instructions in this manual strictly. Save this manual for future use and properly operate installing and using ups unit. Transportation and preparation for usage ... -
Page 3: Operating Principle
AVR circuit modify it and then supply UPS output. At last in case of power fail inverter starts to power UPS output providing needed AC power using energy stored in batteries. View of UPS LUPUS 600N - 1500N Lupus 600N /1000/1500N with IEC 320 outlets... - Page 4 Lupus 1000/1500N with mixed IEC 320 & CEE7 FR outlets AC input wire Input AC breaker UPS protected outlets RJ 45 FAX/Modem /LAN protection USB communication port UPS INSTALLATION DEMANDS UPS should be placed on flat and clean surface. Should be protected against: dust, vibrations, humid and chemically aggressive environment or high temperature.
-
Page 5: Ups Power On
UPS POWER ON Ups will turn ON automatically after placing plug into AC wall socket. For switching OFF UPS main front switch must be pressed ON for 3-4 seconds. On LCD screen will be shown "UPS OFF". In order to switch ON ups when is no AC power ("cold start") main front switch must be pressed for about 2-3 seconds, and for turning OFF in battery mode operation main switch should be used for about 4 -5 seconds. -
Page 6: Trouble Shootting
TROUBLE SHOOTTING Problem Possible cause Solution UPS cannot turn on, Battery voltage < 10V Charge batteries LCD no light PCB failure Factory Service UPS is permanently on Bad AC connection Connect ups properly to AC source battery mode AC breaker activated Check load level, switch on breaker PCB failure Factory Service... -
Page 7: Battery Exchange
BATTERY EXCHANGE Typical life time of VRLA batteries is 3 to 5 years. Temperature above 25°C, frequent deep discharge may make this period even shorter. WARNING !!! - Exchange of battery should be done by qualified personnel. - Batteries Exchange must be done when ups is disconnected from load and mains source. -
Page 8: Software Monitoring
6. Place new batteries inside, connect wires proper way as it was before and close cover. 7. UPS is ready to operate with new battery set. SOFTWARE MONITORING UPS could communicate with computer via USB port using cable A-B type. Cable is included in UPS set with individual license number KEY for software. -
Page 9: Warranty Terms
WARRANTY TERMS ( for POLAND area only) UPS warranty is given for 24 months from date of invoice. Any failures reviled during this period will be solved without any cost in term no longer than 14 days from delivery of unit to authorized service point. Warranty is perform in "door to door"...
Need help?
Do you have a question about the LUPUS 600N and is the answer not in the manual?
Questions and answers