Coleman 5040 Repair And Replacement Procedures page 6

Model 5040 A Repair Manual
To replace knob(s), refer to Figure 12.
Note: Knobs are a friction fit. To remove pull straight out on knob (Figure 12). When replacing knob,
flat side of knob hole must match flat on shaft that extends from the control console.
To replace igniter, refer to Figures 9 and 13-14.
Remove 3 electrode wires from igniter (Figures 9 & 14). Remove igniter cap and battery (Figure 13).
Remove ribbed collar (Figure 13A). Now remove igniter through the maintenance port opening
(Figure 14A).
Figure 12A Figure 13
Figure 12
Figure 14 Figure 14A
Figure 13A
6