Led Indicators; Flir A68/A38 Series Led States; Figure 4: Flir A68/A38 Series Led Startup Sequence; Table 8: Flir A68/A38 Series Led States - Teledyne FLIR A68 Series User Manual

LED Indicators

The FLIR A68/A38 series has one multicolor LED to provide a simple visible indication
of camera state conditions.

FLIR A68/A38 Series LED States

After the A68/A38 connects to a network and an IP address is assigned, the Status LED
will turn to steady blue. Only at this time will it be possible by the GigE Server or any
application to communicate with the camera. The following table summarizes the LED
states and corresponding camera status.

Table 8: FLIR A68/A38 Series LED States

No power to the camera.
OFF
Initial state on power up before flashing. Remains as steady Red only if there is a
fatal error. Camera is not initialized.
Initialization sequence in progress.
IP address assigned.
Application connected.
Note: Even if the FLIR A68/A38 series camera has obtained an IP
address, it might be on a different subnet than the NIC it is attached to.
Therefore, if the A68/A38 LED is blue but an application cannot see it,
this indicates a network configuration problem. Review troubleshooting
suggestions in the Network Imaging manual.
FLIR A68/A38 Series LED States on Power Up
The following LED sequence occurs when the A68/A38 camera is powered up and
connected to a network.
FLIR A68/A38 Series IR Camera User's Manual

Figure 4: FLIR A68/A38 Series LED Startup Sequence

Features and Configuration Options • 37