Image Processing Category; Image Processing Feature Descriptions; Figure 50: Camexpert Image Processing Category; Table 21: Image Processing Feature Descriptions - Teledyne FLIR A68 Series User Manual

Image Processing Category

The Image Processing category, as shown by CamExpert, groups parameters used to
configure defective pixel map replacement, noise, column and median filters, as well as
zoom factors.
For more information on using defective pixel maps and the median filter, refer to the
Defective Pixel Correction and Median Filter sections, respectively.

Image Processing Feature Descriptions

The following table describes these features along with their view attribute.

Table 21: Image Processing Feature Descriptions

Display Name
Noise Filter Mode
Low
Medium
High
Median Filter Mode
Off
Full
Selective
112 • Operational Reference

Figure 50: CamExpert Image Processing Category

Feature & Values
noiseFilterMode
medianFilterMode
Description
Sets how the camera filters out noise
from the image.
Filtering is activated but its effect is
Low
kept minimal. Few artifacts should be
seen in the image.
Enables noise filtering. Some
Medium
artifacts may be visible when the
camera scene changes rapidly.
Enables noise filtering. Artifacts will
High
be visible when the camera scene
changes rapidly.
Applies a median filter (non-linear
smoothing operation) using a 3x3
kernel to the image, which reduces
noise artifacts.
Off Disables median filter.
Full Applies the median filter to every
pixel in the image.
Applies median filter to the worst
Selective
pixels only.
FLIR A68/A38 Series IR Camera User's Manual
View
Beginner
DFNC
Beginner
DFNC