Installation Work; Transportation And Handling - Hitachi air365 Max Series Installation & Maintenance Manual

Table of Contents

Advertisement

4. Installation Work

4.1 Transportation and Handling

4.1.1 Transportation
Transport the product as close to the installation
location as practical before unpacking.
When using a crane, hang the unit according to the
description of the label attached to the outdoor
unit.
WARNING
Do not hang the unit with the sling belts at
the wooden base.
CORRECT
Sling Belt
Wooden Base
INCORRECT
Sling Belt
CAUTION
The unit shall not be handled by one
person. Do not use the PP band to move
the unit although the unit is packed by PP
band. Additionally, do not touch the heat
exchanger with bare hands. The fin of heat
exchanger may cause injuries.
Transportation and Storage
The corrugated paper frame is not
sufficiently strong. Therefore, follow the
instructions below in order to prevent the
unit deformation.
○ Do not step or put any material on the
product. It may cause injury.
○ Apply two sling belts onto the outdoor
unit, when lifting it with a crane.
Transportation and Wire Rope
○ To protect the unit, do not remove any
packing.
○ Do not stack or put any material on the
product.
○ Apply wire ropes on both sides of the unit
as shown in the figure.
For Sling Belt and Fork
For Fork
For Sling Belt
Wooden Base
Plastic Bands
Corrugated
Paper Frame
Do not remove
corrugated paper
frame and plastic
bands.
Take special care when hanging or moving the
outdoor unit because its center of mass is eccentric
as shown in the figure below.
Center of Gravity
a
d
e
b
Front Side of Unit
< CNCCLW >
Model
a
RAS-080CNCCLW 1795 950 765 690 535
RAS-100CNCCLW 1795 950 765 690 535
RAS-120CNCCLW 1795 950 765 690 535
RAS-140CNCCLW 1795 950 765 690 535
RAS-160CNCCLW 1795 1210 765 735 635
RAS-180CNCCLW 1795 1210 765 735 635
RAS-200CNCCLW 1795 1210 765 735 635
RAS-220CNCCLW 1795 1600 765 700 830
RAS-240CNCCLW 1795 1600 765 700 830
RAS-260CNCCLW 1795 1600 765 700 830
RAS-280CNCCLW 1795 1600 765 700 830
RAS-300CNCCLW 1795 1600 765 700 830
4. Installation Work
Attach four 15mm thick
corrugated corner pads
as shown.
Wooden Base
Center of Gravity
f
c
(mm)
380 - 415V/50Hz
380V/60Hz
b
c
d
e
f
330
330
330
330
345
345
345
320
320
320
320
320
19

Advertisement

Table of Contents
loading

Table of Contents