Protecting Against Electrostatic Discharge; Unpacking The Hardware - NETGEAR ProSafe FSM7328S Hardware Installation Manual

Hardware Installation Guide for Managed Stackable Layer 3 Fast Ethernet Switches

Protecting Against Electrostatic Discharge

You can also take the following steps to prevent damage from electrostatic
discharge (ESD):
1. When unpacking a static-sensitive component from its shipping carton, leave
it in the antistatic package until you are ready to install it. Just before
unwrapping the antistatic package, discharge static electricity from your body.
2. Before moving a sensitive component, place it in an antistatic container or
package.
3. Handle all sensitive components in a static-safe area. If possible, use antistatic
floor pads, workbench pads, and an antistatic grounding strap.

Unpacking the Hardware

Check the contents of the boxes to make sure that all items are present before
beginning the installation.
1. Place the container on a clean flat surface and cut all straps securing the
container.
2. Unpack the hardware from the boxes.
Carefully remove the hardware and place it on a secure and clean surface. See
"Select a Location" on page 3-4.
3. Remove all packing material.
3-2
Warning: Static electricity can harm delicate components inside your
system. To prevent static damage, discharge static electricity
from your body before you touch any of the electronic
components, such as the microprocessor. You can do so by
periodically touching an unpainted metal surface on the
switch.
v1.0, March 2006
Hardware Installation