NETGEAR ProSafe FSM7328S Hardware Installation Manual page 28

Hardware Installation Guide for Managed Stackable Layer 3 Fast Ethernet Switches
Console port on rear panel
Figure 3-5
2. Connect the other end of the cable to a workstation or terminal.
3. If you attached a workstation, start a terminal-emulation program.
•
•
•
4. Configure the terminal-emulation program to use the following settings:
•
•
•
•
•
After you connect a console to the switch, you will need to configure the switch.
The following documents are provided for this purpose:
• Quick Install Guide: Explains basic set up and configuration (provided as
both a print document and in PDF format on the NETGEAR CD)
• Command Line Interface Reference for the ProSafe 7300S Series Layer-3
Stackable Switches: Gives detailed examples of how to use the CLI, and is
located on the NETGEAR CD.
• Administration Manual for the ProSafe 7300S Series Layer-3 Stackable
Switches: Describes configuration tasks, and is located on the NETGEAR
CD.
3-10
Microsoft Windows users can use HyperTerminal, which comes with the
Windows operating systems.
Macintosh users can use ZTerm.
UNIX users can use a terminal emulator such as TIP.
Baud rate: 9,600 bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
v1.0, March 2006
Hardware Installation