Bosch GSA18V-110 Operating/Safety Instructions Manual page 10

Table of Contents

Advertisement

Available languages

Available languages

To install the blade (Fig. 2):
Slide the saw blade (1) into the saw blade
holder (4) slot. Make sure the blade is se-
curely locked in place.
If the blade does not snap into place it may
be necessary to reset the LockJaw blade
holder.
1. Turn the locking sleeve (3) for blade hold-
er (4) approximately 90° in the direction
shown, until it locks into the open posi-
tion and a clicking sound is heard.
2. Then repeat insertion of the blade, check-
ing to make sure it is securely locked in
place.
NOTE: Most blades can be installed with
teeth pointing either up or down, as desired
for the application.
To remove the blade (Fig. 3):
Turn the Locking sleeve (3) for blade holder
(4) approximately 90° in the direction shown
(Fig. 2). The blade should spring eject how-
ever due to contaminants it may be necessary
to pull the blade (1) out of the blade slot.
NOTE: be careful, blade may be hot.
Inserting and Releasing Battery
Pack
Ensure the switch is in
the off position before in-
serting battery pack. Inserting the battery
pack into power tools that have the switch on
invites accidents.
Slide charged battery pack (11) into the hous-
ing until the battery pack locks into position
(Fig. 4).
Your tool is equipped with a secondary lock-
ing latch to prevent the battery pack from
completely falling out of the tool housing,
should it become loose due to vibration.
To remove the battery pack (11), press the
battery pack release button (10) and slide
the battery pack forward (Fig. 4).
Press the battery pack release button (10)
again and slide the battery pack completely
out of tool housing (Fig. 4).
GSA18V-110 202206.indd 10
page heading
Assembly
Fig. 2
(1)
Fig. 3
(1)
Fig. 4
(10)
(11)
-10-
(3)
(4)
(3)
8/17/22 8:24 AM

Advertisement

Table of Contents
loading

Table of Contents