Maintenance And Cleaning; Recommended Cable Management - Maxeon SPR-P6-555-UPP Installation Instructions Manual

POWERING POSITIVE CHANGE
During storage, modules need to be protected from rain or any kinds of liquids.
Required storage temperature is between 10°C to 40°C in a dry environment
(humidity between 30 to 80%). Do not store modules outdoor to avoid moisture
and wet conditions.
Modules that feature antireflective coated glass are prone to visible finger print
marks if touched on the front glass surface. Maxeon recommends handing
modules with anti-reflective glass with gloves (no leather gloves) or limiting
touching of the front surface. Any finger print marks resulting from installation
will naturally disappear over time or can be reduced by following the washing
guidelines in Section 6.0 below. Any module coverage (colored plastic tarps or
similar) during installation can lead to permanent front glass discoloration and is
not recommended. The use of vacuum lifting pads can cause permanent marks
on the front glass. Never lift or move the module using the cables or the junction
box under any-circumstances.
System energization and shutdown procedures need to be followed based on
respective National guidelines and local regulations. Safe site operational
practices must be adhered before energizing the PV system (e.g. electrical
continuity, avoiding direct contact with electrical/framing equipment, wearing
safety PPE, etc.). System should be electrically disconnected during maintenance,
upgrades, and modification works which can affect the operation of PV system.

6.0 Maintenance and Cleaning

Trained Maxeon dealer or trained Maxeon support personnel should inspect all
modules annually for safe electrical connections, sound mechanical connections,
and freedom from corrosion.
Periodic cleaning of module glass has resulted in improved performance levels,
especially in regions with low levels of annual precipitation; therefore Maxeon
recommends periodic cleaning of the modules.

Recommended Cable Management

Performance Product Line:
Portrait Stringing
Leapfrog Stringing (Portrait)
Landscape Stringing
*The images are solely for illustration purposes only.
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in these instructions are subject to change without notice. "MAXEON" and "POWERING POSITIVE CHANGE" are registered trademarks in certain
countries. View warranty, patent and trademark information at https:/corp.maxeon.com/trademarks.
Safety and Installation Instructions - Document 539821 Rev.D
To clean a module, wash its glass surface with potable, non-heated water.
Normal water pressure is more than adequate when cleaning the AR glass.
Maxeon recommends using a large hosepipe and not to perform cleaning at high
outside temperatures. Some fingerprints, stains, or accumulations of dirt on the
glass may be removed with over-the-counter glass cleaners (such as Windex
equivalent), or a 3% soap-and-water solution. For smaller systems, wet the
with
module glass with the solution, let it stand for five minutes, and then wet them
again and use a soft sponge or seamless cloth to wipe the glass surface in a
circular motion. For large systems, wet the modules with the cleaning solution,
let them stand for five minutes, and then rinse them with high-pressure water or
a soft sponge. Do not use harsh industrial-strength cleaning materials such as
scouring powder, steel wool, scrapers, blades, or other sharp instruments to
clean the module glass. Use of such materials will void the product warranty.
MAXEON SOLAR TECHNOLOGIES, LTD.
®
or
Page | 5