Managed Layer 3 Switches FSM7326P, GSM7312, and GSM7324 Hardware Installation Guide
4. Configure the terminal-emulation program to use the following settings:
•
•
•
•
•
After you connect a console to the switch, you will need to configure the switch.
The following documents are provided for this purpose:
•
Quick Install Guide: Explains basic setup and configuration (provided as both
as a print document, and in PDF format on the NETGEAR CD)
•
Command Line Interface Reference for Layer-3 Switches: Gives detailed
examples of how to use the CLI, and is located on the NETGEAR CD.
•
Administration Manual for the Layer-3 Switches: Describes configuration
tasks, and is located on the NETGEAR CD.
Hardware Installation
Baud rate: 9,600 bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
v1.0, March 2006
3-9