Step 6: Applying Ac Power; Step 7: Switch Management Through A Web Browser Or The Pc Utility For Initial Configuration; Figure 4-3. Installing A Gigabit Ethernet Module Into Fs726Tp - NETGEAR ProSafe FS726TP Hardware Installation Manual

Figure 4-3. Installing a Gigabit Ethernet Module into FS726TP

Step 6: Applying AC Power

NETGEAR ProSafe FS726TP Smart Switch with PoE does not have an ON/OFF switch; the only method of applying or removing AC power is by
connecting or disconnecting the power cord. Before you connect the power cord, select an AC outlet that is not controlled by a wall switch, which
can turn off power to the switch. After you select an appropriate outlet, use the following procedure to apply AC power.
Connect the female end of the supplied AC power adapter cable to the power receptacle on the back of the switch.
Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC outlet.
When you apply power, the Power LED on the switch's front panel will be Green.
If the Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the
problem, refer to Appendix B, Troubleshooting.

Step 7: Switch Management through a Web Browser or the PC Utility for Initial Configuration

Your NETGEAR ProSafe FS726TP Smart Switch with PoE contains software for viewing, changing, and monitoring the way it works. This
management software is not required for the switch to work. You can use the ports without using the management software. However, the
management software can let you setup VLAN and Trunking features and also improve the efficiency of the switch and, as a result, improve its
overall performance as well as the performance of your network.
After you power-up the switch for the first time, you can configure it using a Web browser or a utility program called Smart Wizard Discovery. For
more information about managing the switch, see the Software Manual on the Smart Switch Resource CD.
Page 14 of 19