Reset Button; Factory Defaults Button - NETGEAR ProSafe FS726TP Hardware Installation Manual

Reset Button

The FS726TP has a Reset Button to trigger a hardware reset of the switch. This is equivalent to turning the power off and back on. The last saved
configuration will be loaded onto the switch as it resets. To press the Reset Button, insert a small device such as a paper clip into the opening to
press the recessed button. The LEDs on the switch should go out and then come back on as the switch goes through its Power On Switch Test
(POST).

Factory Defaults Button

The FS726TP has a Factory Default Button to enable you to clear out the current configuration and return to the factory settings. This will clear out
all settings, including the password, VLAN settings and port configurations.
Page 11 of 19