Coleman 9992-647 Use, Care & Assembly Manual page 14

NOTE: Your 8400 Series grill is set up from the factory to use LP GAS. If you want to use NATURAL
GAS, you must purchase the NATURAL GAS CONVERSION KIT (sold separately). Please skip
to the section titled "Natural Gas Installation".
LP Cylinder Installation
1. Open the right door and slide out the cylinder support. Set the
LP cylinder in the cylinder support location with the outlet valve
facing toward the right side of the grill (Fig. 27).
2. Insert the TYPE 1 Nipple of the regulator into the cylinder's fuel
valve outlet as shown (Fig. 28). Turn the regulator hand wheel
clockwise to tighten. No tools are needed. The hand wheel will
come to a complete stop when the connection is secure, and the
gas will not flow until a positive seal is achieved.
3. Slide the cylinder support back into the grill (Fig. 29).
T
O ENSURE PROPER GAS FLOW
CONTROL VALVES MUST BE
OPENING THE GAS CYLINDER VALVE
WARNING:
of the grill and when attaching or
replacing the L.P. gas cylinder,
insure that the gas supply hose is
free of kinks and/or damage and
is at least 3 inches away from hot
surfaces such as the grill casting.
14
Grill Assembly — 8400 Series
IMPORTANT!
,
BURNER
"OFF"
During assembly
BEFORE
.
Fig. 27
Fig. 28
Fig. 29