Dc Out Connector - Sony AXS-R7 Service Manual

2-16.

DC OUT Connector

Preparation
1. Remove the docking module. (Refer to
2. Remove the IF-1308 board assembly. (Refer to
Procedure
1. Remove the DC OUT connector.
(1) Disconnect the harness from the connector (CN205) on the DC-181 board.
(2) Remove the nut, and then remove the DC OUT connector.
Note
If the nut cannot be removed easily due to adherence of locking compound (TB1401B), apply alcohol to the nut
to dissolve the locking compound and then loosen the nut.
Harness
CN205
DC-181 board
Note
When installing the DC OUT connector, observe the following instructions.
• When attaching the DC OUT connector, apply locking compound to one screw portion of the DC OUT
connector.
• Do not use the star washer supplied with the new DC OUT connector.
2. Install the removed parts by reversing the steps of removal.
AXS-R7
"2-2. Docking Module")
"2-14. IF-1308
Nut
Locking compound application area
Thread of the DC OUT connector
Board")
DC OUT connector
2-34