Sony AXS-R7 Quick Start Manual

Hide thumbs Also See for AXS-R7:

Introduction

This document describes how to update the AXS-R7

firmware to the latest version.

You will need to save the update data to a USB storage

device before performing update.

Use a USB storage device with a capacity of 4 GB to

32 GB.

Format the USB storage device on a computer, for

example.

The format conditions are as follows.

• File system: FAT32

• Allocation unit size: 32 KB

Note

Version update cannot be performed under conditions

other than the above.

Save the update data to the root directory of the

formatted USB storage device.

Do not store any other data on the USB storage

device.

Use the recommended AC-DN10 or AC-DN2B AC

adapter.

AXS-R7

4-736-142-11 (1)

Table of Contents

Do you have a question about the AXS-R7 and is the answer not in the manual?

Page 1 AXS-R7 Introduction Preparation This document describes how to update the AXS-R7 Preparing the USB Storage Device firmware to the latest version. You will need to save the update data to a USB storage Use a USB storage device with a capacity of 4 GB to device before performing update.
Page 2 Updating the Firmware When the update button is pressed, the TALLY lamp and POWER indicator light and the unit turns on. The TALLY will blink after about 3 seconds and then Performing Version Update remain steadily lit again when version update starts. TALLY lamp Note POWER indicator...
Page 3 Disconnect the DC power supply after version update is complete, and turn the unit off. Remove the USB storage device, and secure the plate to the bottom of the unit with the screws.