Coleman 9992-643 Use, Care & Assembly Manual page 13

Side Burner Installation
From underneath the side shelf, push the threaded portion of the
10.
electrode module through the round hole (Fig. 22).
Assemble the plastic hex nut and igniter button back onto
11.
the electrode module. These items should be hand
tightened only (Fig. 23).
Assemble the side burner control knob (Fig. 24).
12.
The igniter wire for the side burner is shipped loose. Attach the
13.
large spade to the igniter terminal underneath the side burner
(Fig. 25).
Attach the small spade to one of the four open terminals on the
14.
electrode module (Fig. 26a). Notice that the wire may be neatly
wrapped around the fuel line.
Three wires are factory installed to the main burner electrodes.
15.
Locate the loose ends of these three wires (they exit the right
side panel through a grommet) and attach them in any order to
the tabs in the back of the electrode module (Fig. 26b).
NOTE: It does not matter which ignition wire goes to which tab
on the electrode module.
Grill Assembly — 8100 Series
(continued)
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26a
Fig. 26b
13