Related Manuals for Avonic AV-MT300
Summary of Contents for Avonic AV-MT300
- Page 1 USER MANUAL Avonic Wall and Ceiling Mount AV-MT300 www.avonic.com • © January 2023 • Version 1.0...
-
Page 2: Disclaimer, Contact And Ce Marking
“look and feel” and arrangement of such Content, contained in this Manual is owned, controlled or licensed by or to Avonic, and is protected by trade dress, copyright, patent and trademark laws, and various other intellectual property rights and unfair competition laws. -
Page 3: Important Information
IMPORTANT INFORMATION Liability Avonic will NOT be held responsible for any damage or injury caused by unqualified persons carrying out these tasks, or by not following the instructions in this Manual. Intended Use and Non-Intended Use Installation The following applies to the installation of the mount and the camera: •... -
Page 4: Acronyms
Symbol Meaning Description Not following the instructions associated with this symbol may lead to Warning personal injury and / or serious damage to the Product. Caution Caution should be exercised with the associated information. The information associated with symbol refers to a general remark or a Information reference to other documentation. -
Page 5: Table Of Contents
Contents DISCLAIMER, CONTACT AND CE MARKING..................ii IMPORTANT INFORMATION........................iii Liability............................iii Intended Use and Non-Intended Use..................iii Installation.......................... iii Operation.......................... iii Important Precautions...................... iii Symbols Used in This Manual..................... iii Acronyms............................ iv INTRODUCTION............................6 Purpose of This Manual......................6 Target Audience......................... 6 Document Structure........................ -
Page 6: Introduction
This Manual describes the safety precautions and the instructions for safe unpackaging, installation, operation, maintenance and disposal of the Avonic MT300 Mount. In this Manual the Avonic MT300 Mount is referred to as the 'Product'. Target Audience This Manual is developed for installation technicians who install the Product at client sites, and for IT professionals who are responsible for operating the Product. -
Page 7: Safety Instructions
• Set up this Product on a hard, stable surface or mount it to a wall or ceiling. • ONLY use an Avonic mount for mounting to a wall or ceiling. • Ensure the mounting construction is capable of supporting four times the weight of the Product. (See 'General Specifications >... -
Page 8: Ventilation
• Don’t open this Product and don’t attempt to repair it yourself. Disassembling the Product may damage it or may cause injury to you. • If this Product is damaged, malfunctioning, or if it comes into contact with liquid, contact Avonic or an Avonic Authorized Service Provider. -
Page 9: Product Overview
Description The Avonic MT300 wall and ceiling mount is a solid wall and ceiling mount suitable for the support of the CM93 PTZ camera. Its discrete design matches the silent operation of Avonic PTZ cameras. The wall and ceiling mount is a beautiful extension that not only ensures great and safe support of the PTZ cameras but also allows for all the cables to be hidden inside the mount. -
Page 10: Unpacking
Package Contents The following tables contains an overview of the package contents of the Product. Quantity Description Avonic SKU 1 pc Ceiling mount AV-MT300-B/ -W AV-MT300-B/ -W 1 pc 1/4”-20 UNC Central Camera Screw 5 pc M3*6mm DIN9785 black screw... -
Page 11: Unpacking The Mount
The mount should be in its protective foam as follows: Figure 2: Mount in bag 3. Verify that the plastic mount bag is sealed. If this is NOT the case, contact Avonic and stop here. 4. Break the seal of the sealed mount bag. -
Page 12: Mounting And Installation
• Set up this Product on a hard, stable surface, or mount it to a wall or (computer) screen. • ONLY use an Avonic mount for mounting to a wall or ceiling. • Ensure the mounting construction is capable of supporting four times the weight of the Product. (See 'General Specifications >... -
Page 13: Mounting The Camera
The screws and plugs are not included. See Package Contents what is included. 2. Mounting the Camera 2. Place the CM93 camera on the camera plate and mount the camera plate to the camera using three of the M3*6mm black screws AND the (only one silver) 1/4”-20 UNC screw. 3. -
Page 14: Mounting On A Wall Or Mounting Pole
Mounting on a Wall or mounting pole 1. Baseplate To install the mount, follow these instructions: Mount the MT300 baseplate (the bracket) to the wall (Figure 5). It is possible to connect the cables from behind the wall. See the drawings under "Measurements and Specs"... -
Page 15: Cable Cover
Figure 11: Connecting cables Figure 10: Mounting camera to the baseplate 3. Cable Cover 4. Put the cable cover over the back of the bracket, neatly concealing the cables and connectors of the camera. The cover cap can be screwed in place using the supplied M6 Allen bolts (Figure 9) for the MT300. -
Page 16: Mounting Pole
Mounting Pole Follow these instructions if you decide to mount the MT300 to a mounting pole: Use a compatible screw, the 30MM Steel Ring to connect the clamp to the 30 mm gap in the center of the baseplate. It is also possible to use a (third party) mounting adapter and mounting pole. See the pictures below: Ensure that the mounting construction is capable to carry four times the weight of the camera! See the datasheet of the camera for the exact weight. -
Page 17: Measurements And Specs
Dimensions product MM (W x H x D) 153 x 83 x 274 Weight product 1.55 KG Included AV-MT300 Black or white 1 x 1/4”-20 UNC camera screw 1 x 30MM Steel Ring 5 x M3*6mm black screw 2 x black Allen bolt m6* (to hold steel... - Page 18 VIEW B FORM: MATERIAL SCALE: THICKNESS: 2 mm STEEL, 1 : 1,25 MATERIALNR.: EDITION NAME: NW. CAMERA-4K-CEILING MOUNT - POS10 DATE Avonic FILE ARTICLE NUMBER: NW-CAMERA-4K-CEILING MOUNT-POS10-A. PAGE 1 OF 1 SIGNED VALIDATION PARAAF DATE M. SAHIN A. REURINGS 2022-07-05...
-
Page 19: Transport And Storage
TRANSPORT AND STORAGE The mount must be transported in its original packaging box. Inside the box, it is recommended to wrap the mount in the original plastic bag and to place it in the protective foam. Specific guidelines apply to the environmental temperature and humidity when operating and storing the mount and the camera. -
Page 20: Disposal And Recycling
In general, the term 'E-Waste' applies to items of all types of electrical and electronic equipment and its parts that have been discarded by the owner as waste without the intention of re-use. Avonic outsources the disposal and recycling of its E-Waste mount and camera materials to the Stichting Open. https://stichting-open.org/... - Page 21 Avonic Wall and Ceiling Mount AV-MT300 © January 2023 • Version 1.0 Exportweg 11a • 2645 ED Delfgauw • The Netherlands +31(0)15 7112 712 • info@avonic.com • www.avonic.com...
Need help?
Do you have a question about the AV-MT300 and is the answer not in the manual?
Questions and answers