Advertisement
Quick Links
2|
Drill two holes
in the opposite corners
inside of the frame
Installation
manual
UNI
Technical
parameters
size of the
UNI 4
panel
268 mm
size of the
UNI 6
panel
377 mm
1 |
Based on the chosen size,
mark size of the hole in
order to place the panel
3|
Take a jig saw and cut
the hole
A
A
×
A
B
×
127 mm
×
A
B
×
127 mm
Cut the corners
sharply
B
Advertisement
Summary of Contents for PANCONNECT UNI
- Page 1 Technical parameters Installation manual × size of the UNI 4 panel × 268 mm 127 mm × size of the UNI 6 panel × 377 mm 127 mm Based on the chosen size, mark size of the hole in order to place the panel...
- Page 2 Insert the panel into Insert a clip into the groove the hole in the lower part of the panel For the desk height 10- 25 mm use upper groove, for the desk height 24 - 42 mm use lower groove. Use hex key no.3 to tighten If you've chosen pullout for your panel, place it on the lower part of the panel...
- Page 3 If you've chosen CMS for your panel, screw in the cover plate Tighten the screws into the panel to CMS using countersunk-head bolts 10|B Link CMS and cartridge with connection cable (if you have Place CMS to the lower part of the panel more CMS in your panel, connect them as well) and move it to the grooves (in the arrow's direction)