PANCONNECT FLAT 3M Assembly Instruction

ASSEMBLY INSTRUCTION
PANCONNECT FLAT 3M, FLAT 4M, FLAT 5M
General description, basic technical data and other information and instructions find in
the general document „Technical specifications", which is, together with the document
„User manual" supplied with all types of interconnection boxes PanConnect.
1 | Assembling
- Adapted for horizontal installation into desks of thickness from 16 to 40 mm
- The corpus is mounted from the lower side of the table desk with mounting clamps
with screws
Step 1: Cut an opening in the table (the particular size of the opening see below):
Product type
FLAT 3M
FLAT 4M
FLAT 5M
Step 2: Carefully insert the interconnection box into the prepared opening and check if it
fits.
Step 3: Take the mounting brackets under the table and insert them into openings on
both sides of the unit.
Step 4: Secure them by M3x6 screws, and screw the unit up slightly against the board by
screws M6x40.
Step 5: Verify proper alignment of the interconnection box against the table desk, move
them into the right position if need and finally tighten the screws.
Cut-out dimensions (mm)
68 x 184
68 x 242
68 x 300
2 | Connection
Interconnection boxes PanConnect have 2 covers fastened from below by 4 Pcs. of
screws M3x6.
Step 1: Unscrew one of the covers and connect the cables or connectors inside the
corpus of the connecting panel.
Step 2: After connecting, screw the cover back firmly to the corpus of the
interconnection box.
3 | Cautions
PanConnect s.r.o. is not responsible for any damage caused on the table. Connection to
the low-voltage network can provide a qualified person only. Specifications are subject
to change without notice. The surface of the box can be cleaned with non-alcohol based
cleaner.