Abestorm Water Damage Series User Manual
Hide thumbs
Also See for Water Damage Series:
- User manual (10 pages) ,
- User manual (6 pages) ,
- User manual (9 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Abestorm Water Damage Series
Summary of Contents for Abestorm Water Damage Series
- Page 1 Water Damage Series AbesTec 4000i Dehumidifier User’s Manual Abestorm Solutions INC Add:Berlin Tel: +44 (20) 81243974 Email: www.abestorm.com Note: as we keep upgrading our product,we reserve the right to modify the product without natice in advance.
-
Page 2: Table Of Contents
Important Notes The Abestorm® AbesTec 4000i water damage dehumidifier controls humidity in an environment by getting rid of the water vapor present in the air. The Abestec 4000i is ideal for structural drying, water damage Important Notes restoration, construction, and is particularly adapted for eliminating moisture from structural contents... -
Page 3: Warranty Registration
The motor and wiring should be kept dry at all times. Before first use Do not try to repair the equipment on your own. Contact Abestorm to get service from Authorized Service Centers. Warranty Registration To register your dehumidifier, visit abestorm.com. Registering the unit allows us to assist you in the operation, maintenance, and servicing of your unit. - Page 4 Plug-in Electrical cables For maximum efficiency, use both circuits while ensuring that the green light illuminates. Ensure that the cables are firmly plugged in the top compartment and then to the wall However, the dehumidifier may run on one power cord if the second circuit is not outlets.
- Page 5 Ducting Options USER SETTINGS Menu items that are followed by the greater-than (>) symbol can be adjusted. For menu items with read-on data (CURRENT, REACT & HEATER 1, INLET, OUTLET), the display A.Basic Setup returns to normal mode if no key is selected within five minutes. In other menu selections, the display returns to normal mode after about twenty seconds.
-
Page 6: Transportation And Storage
For a wider supply of process air, make cuts of between fourto six inches along the lay-flat at intervals. Tie off the end to increase efficiency. Note: Used filters should only be replaced with new Abestorm filter part # F590 (24pack). Other types of filters do not offer adequate airflow or filtration. -
Page 7: Pump Purge Button
Fig. D: Interior views Inspect the blower and clean as necessary Ensure that the impeller rotates without restrictions. Wipe clean or vacuum all surfaces. Notice! RH/Temperature The sensor cable is attached onto the interior of panel. Before Inspect the desiccant rotor and clean as necessary Setting aside the panel, unclip and slide it out from the cable tie Use pressurized air or dry-vacuum to get rid of dust collected on the rotor. -
Page 8: Troubleshooting
Troubleshooting F533XX None Model number Unit has finished powering None OFF/ON Symptom up and is operating Cause Solution Verify that both ends of the Poor Connection cord are plugged in None Display is Blank Fan will not operate until unit reaches PLEASE WAIT proper operating temperature, Power Outage... -
Page 9: Spare Parts
Spare Parts Specifications Fan Components Remote Control Power 115V/60HZ N-1210 Fan Motor Remote Control Assembly W-100 (includes W-101 and W-102) Amperages(max.) 24Amperes Complete Fan Assembly N-1211 W-101 Remote Control Fan Capacitor Circuit 1:10.7 N-1205 ℉/ 60 % RH) Remote Control Cable Amperages(at 80 W-102 Circuit 1:10.8... -
Page 10: Limited Warranty
3. ANY COSTS DUE TO LOST PROFIT OR DELAY 1. The client should send the warranty card via email to Abestorm will. If there is not card submitted, the warranty starts at the point of dispatch from the warehouse. Note the serial number of the product 4.