Entering Company Data - Dometic AirCon ASC 1000 Operating Manual

ASC_RPA_de_en_nl_da_sv.book Seite 61 Dienstag, 5. Februar 2008 3:10 15
6.3

Entering company data

The company data is printed out with every service log.
1. In standby mode, use the cursor keys
2. Press ENTER to confirm.
3. Use the cursor key
4. Press ENTER to confirm.
5. Enter the password "3282".
6. The company data is shown in the third line of the display (6).
7. Enter the desired data using the keypad (7) and the cursor keys:
8. Press ENTER to confirm.
9. Press STOP. The set data is activated.
10. Press STOP again to go to standby mode.
AirConServiceCenter
"Other selections":
Short selection
Free selection
Other selections
ENTER-OK
to select "Service".
You can enter five lines, each with up to 20 characters.
In the display, the number of the company data row entered appears
after the message "Enter company data." ("01" to "05").
The company data row is selected with the cursor keys
To switch between upper and lower case letters, press the Info
key .
To delete individual characters, press the key C briefly.
To delete the entire display line, keep the key C pressed.
First start-up
or to select
or .
61