Advertisement
Assembly Instructions (Continued)
Once the bag retainer is installed:
4
a. Insert Bag (P), into the 5 Gallon Pail (K) so
the bag is fairly snug to the edges.
b. Fold the top edge of the Bag (P) over the
rim of the 5 Gallon Pail (K) neatly to
minimize the folds which will cause leaks.
c. Place the Steel Lid (I) and turn on your
system.
d. When the 5 Gallon Pail (K) is 2/3 full,
remove the Steel Lid (I) and pull out the
Bag (P), seal, and dispose.
If you wish to use the Mobility Kit (Q):
5
a. Insert the 5/16"-18 Square Nut (Q2) into
the square pocket on the underside of the
Molded Drum Dolly (R) and a 5/16"-18
X 2" J Bolt (Q1) in the indicated holes on
opposing sides of the Molded Drum Dolly
(R). DO NOT overtighten [FIG. 6].
b. Secure the Rubber Strap with S Cuffs (Q3)
at their halfway point underneath each J
Bolt (Q1) as shown in [FIG. 6].
c. Place 5 Gallon Pail (K) in center of Molded
Drum Dolly (R), and then place the
assembled unit on top of it
d. Hook the Rubber Straps S Cuffs (Q3) into
the holes on the Steel Lid (I) in order to
secure the assembled unit to the Molded
Drum Dolly (R)[FIG 7].
WARNING: DO NOT OVERSTRETCH RUBBER
STRAPS
FIG. 5
FIG. 6
FIG. 7
oneida-air.com
4 4
Advertisement
