Advertisement
Assembly Instructions
Place Gasket for Cyclone (H) over the center
1
hole in the Steel Lid (I) and line up the holes.
Secure the Cyclone (F) using the 1/4"-20 X 3/4"
Bolts (G1), 1/4" Flat Washers (G2), and 1/4"
Flange Nuts (G3) from the Hardware Pack (G)
as shown in [FIG. 1]
Place the 12" Diameter Gasket (J) over the lip
2
along the rim of the 5 Gallon Pail (K) as shown
in [FIG 2] & [FIG 3]
NOTE: Double Ribs of gasket are facing up, and
the gasket wraps around lip of drum.
If you wish to use bags, first install the bag
3
retainer:
a. Drill a ½" diameter hole about 1-½" from
the bottom edge of the 5 Gallon Pail (K).
b. Screw the 1/4" Tube Fitting (N) into the
newly drilled hole, it will form its own
threads. Carefully and gently, use a wrench
to screw it all the way in, over tightening
will strip the threads.
c. Attach the 2" Elbow with 1/4" Fitting (C) to
the top outlet of the Steel Cyclone. (F)
d. Insert one end of the 1/4" OD Clear Vinyl
Tubing (N) into the 2" Elbow with 1/4"
Fitting (C) and the other end into the fitting
at the base of the 5 Gallon Pail (K).
NOTE: Using a bag with the Dust Deputy will
help minimize exposure to trapped dust
3
Oneida Air Systems
FIG. 1
FIG. 2
FIG. 3
FIG. 3
Advertisement
