Toro Greensmaster TriFlex 3300 Series Operator's Manual page 3

2. Push the motor retaining bar out of the slots on the
motor towards the tri-roller unit and remove the motor
from the tri-roller unit.
2
1
1. Motor
3. Move the motor to the storage location on the front of
the suspension arm.
Note: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result. If you must move the traction unit without the
tri-roller units installed, secure them to the suspension
arms using cable ties.
4. Open the latches on the suspension-arm bar of the
tri-roller unit you are removing.
5. Disconnect the latches from the tri-roller unit bar.
6. Roll the tri-roller unit out from under the suspension
arm
7. Repeat steps 2 through 6 for the other tri-roller units
as required.
Operation
Training Period
Before rolling greens, we suggest that you find a clear area
and practice starting, stopping, raising, lowering, and rolling
with the tri-roller. This training period will be beneficial to
the operator in gaining confidence to the performance of
the tri-roller.
Operating Tips
Maintain a straight line when rolling. Do not turn when the
tri-rollers are on the ground.
When the edge of the green has been reached, raise the
tri-rollers before turning or stopping. The tri-rollers must be
Figure 4
2. Motor retaining bar
raised completely before making turns. Survey the green to
determine if there are any obstacles that will be damaged or
will result in damage to the rollers, such as sprinkler heads
and protruding objects.
Maintenance
Lubrication
Lubricate the 2 grease fittings (Figure 5) on each tri-roller unit
after every 15 hours of operation, using a #2 multi-purpose
lithium base grease. A hand operated grease gun is
recommended for best results.
1. Wipe each grease fitting with a clean rag.
2. Apply grease to the tri-roller shaft bearings until you
feel pressure (Figure 5).
g014605
3. Wipe excess grease away.
3
G018317
Figure 5