Toro Greensmaster TriFlex 3300 Series Operator's Manual page 2

1
Installing the Tri-Roller Units
No Parts Required
Procedure
1. Position the tri-roller unit under the suspension arm.
2. With the latches on the suspension-arm bar pointing
up (i.e., Open)(Figure 1) push the suspension arm
down so that the bar fits over the bar across the top of
the tri-roller unit (Figure 2).
1. Latch—closed position
2. Suspension-arm bar
1. Suspension-arm bar
3. Close the latches down and around the tri-roller unit
and lock them in place (Figure 1).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
3. Latch—open position
G018312
Figure 2
2. Tri-roller unit bar
4. Insert the motor into the left side of the tri-roller unit
(as viewed from the operator's position) and pull the
motor retaining bar on the tri-roller unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure 3).
G01831 1
1. Motor
2. Spline shaft
2
Removing the Tri-Roller Unit
No Parts Required
Procedure
1. Park the machine on a clean level surface, lower the
tri-roller units to the ground until the suspension
hydraulics are fully extended, stop the engine, set the
parking brake, and remove the key from the ignition
switch.
2
2 3
1
Figure 3
3. Cavity
4. Motor retaining bar
Contact us at www.Toro.com.
4
g014690
Printed in the USA.
All Rights Reserved